I am a senior embedded system engineer and have a good experience in pcb design and firmware programming for prototype alone. In other words, I can do from the schematic and pcb design to firmware programming. Electrical circuit design and pcb design using the Altium Designer and Eagle, Kicad. For Firmware I have deeply knowledge about several family microcontroller such as PIC, STM32, ATMEL, TMS320C, ESP32 CC26XX and nrf51822 , CC2640 for Bluetooth.. -Raspberry Pi Programming with python..(Python 2.7) and then I can use several programming tools such as CCS & IAR, MPLAB & MikroC, Keil, and so on. Also i have worked with Verilog/vhdl for 5 years and used Quartus to develop EP1C12Qxx and EP3C.. + DSP... and Xilinx. I am developing electronic devices for over 7 years. Design a wiring diagram, develop printed circuit boards, printed circuit board layouts are made, I produce an assembly board, write the program for the device and debug programs, and printed circuit board. I have extensive experience in developing various sensors. While job processing, I will always take care of each and every detail and try to come up with the best solution for your business success and be ready to communicate anytime you want. Best Regards