I'm an Electronics Design Engineer holding a Master's degree in Electrical Engineering with +2 years of experience. 

I had some experience in designing PCBs and RF/microwave and millimeter-wave components (filters, antennas, diplexers...) and systems (RFID, Battery charging System). 

Most of my experience comes using the following software: Kicad, EasyEDA, Altium, ADS, CST, and HFSS.

Recently, I have worked on the design of an RF transmitter (PCB board) for an RFID reader; 

The broad consist of: Antenna; Bandpass Filter; Power Amplifier; Oscillator...

I also participated in working on the development of a new charging System.

I have experience in using measurement tools for RF components such as VNA and oscilloscopes.

I have published three book chapters and two articles in international journals.